Hall effect measurement demonstrated that, compared to the kesterite CZTS films, the wurtzite CZTS films show a higher carrier concentration and lower resistivity. The high carrier concentration and low resistivity mean high electrical conductivity, which would result in the wurtzite ABT-263 nmr CZTS which is more favorable when used as CE in DSSC. In former reports, the CZTS materials used as CEs usually possess the kesterite structure [19–21]; however, the wurtzite CZTS has not yet been reported as a CE in DSSCs. Herein, for the first time, using CZTS NC films as CEs, we discussed the effect of wurtzite and kesterite CZTS crystal structure

on the photovoltaic performance of DSSCs. Through various characterizations, such as cyclic voltammetry and electrochemical impedance spectroscopy, the

obtained wurtzite CZTS NC film was demonstrated as a more effective CE material to selleck chemicals llc replace the expensive Pt, yielding a low-cost, high-efficiency DSSC compared to the kesterite CZTS CE. Methods Fabrication of the CZTS thin film for CE The synthetic process of kesterite and wurtzite CZTS NCs was similar as before [18]. The CZTS NCs were finally dissolved in tetrachloroethylene and concentrated to 10 mg/mL. Then, CZTS NC films were fabricated on a FTO glass by drop coating method using the obtained ‘nano-ink’. The thickness of the two CZTS layers prepared by dropcasting was about 2 μm. After coating, the CZTS NC films were vacuum-dried at 60°C, and then a post-annealing process was conducted in argon atmosphere at a rate of 2°C/min and held at 500°C for 30 min. Device assembly Porous TiO2 photoanodes were immersed overnight Defactinib concentration in 0.3 mM ethanolic solution of N-719 at room temperature to absorb the dye. The TiO2 photoanodes were then taken out and rinsed with ethanol to remove the excess dye adsorbed and dried in air at room temperature. The sandwich-type solar cell was assembled by placing the CZTS CE on the N-719 dye-sensitized photoelectrode (working electrode) and clipped together as an open cell for measurements. Sulfite dehydrogenase The cell was then filled with a liquid electrolyte composed of 0.1 M anhydrous LiI, 0.12 M

I2, 1.0 M 1,2-dimethyl-3-n-propylimidazolium iodide (DMPII), and 0.5 M tert-butylpyridine in dehydrated acetonitrile by capillary force. Results and discussion Crystal structures of the CZTS thin films after annealing were confirmed by XRD patterns (Figure 1). The major diffraction peaks of the kesterite CZTS thin film can be indexed to kesterite CZTS (JCPDS 26–0575) [22–24] (red curve) and to cation-disordered wurtzite CZTS [25] (black curve), respectively. No characteristic peaks of other impurities are detected, such as ZnS, CuS, or Cu2S. Figure 1 X-ray diffraction patterns of the as-obtained CZTS thin films after annealing. Figure 2 shows scanning electron microscopy (SEM) images of the cross section of the kesterite (d) and wurtzite (b) CZTS thin films with sintering at 500°C for 30 min, respectively.