, 2007, Schmaranzer and Stabentheiner, 1988, Stabentheiner et al., 2012 and Stabentheiner and Schmaranzer, 1987). The measurement

accuracy of 0.7 °C was achieved by using a self-constructed Peltier driven reference source of known temperature and emissivity. Infrared data were recorded digitally on hard disk at 3, 5 or 10 frames s−1. Evaluation of the surface temperatures of head (Thd), thorax (Tth) and abdomen (Tab) was done with Selleckchem PLX4032 AGEMA Research software (FLIR Systems Inc.) controlled by a proprietary Excel (Microsoft Corporation) VBA macro. The thermographic video sequences also allowed judgment of active and resting periods without behavioral impairment. Endothermy was assessed by the difference between Tth and Tab. As these temperatures were both surface temperatures measured via IR, we minimized measurement errors which possibly might occur PFT�� purchase when calculating Tth from IR and Ta from thermocouple data. Our definition of rest (classification according to Crailsheim et al., 1999, Stabentheiner and Crailsheim, 1999 and Stabentheiner et al., 2003) was: (1) The individual was ectothermic (no visibly heated thorax) and (2) there were no or marginal signs of bodily activity (i.e. movements of antennae, single movement of legs allowed) for a duration of at least 10 min (reduced to 5 min at temperatures >27.6 °C if no 10 min intervals were available). However, we were forced to take into account

that individuals, although being obviously at rest (sitting still for an hour or

Amoxicillin more), could be slightly endothermic. Therefore we had to define “rest” in terms of “scarce movement” and “only weak endothermy” with Tth − Tab < 2 °C during a few periods of the experiment. Before we determined the amount of carbon dioxide produced in a certain experimental trial, the IR video sequences were analyzed concerning the wasps’ activity. Sections assessed as “resting periods” (defined in Section 2.3) were divided up into 10 min intervals. At high T  a (27.6 °C and above) phases of inactivity in some individuals decreased in duration as well as in number to such an extent that we had to reduce the minimal interval for our definition of “rest” to 5 min. URAS 14 CO2 data from these time intervals were used for further calculations. Integrating the gas exchange cycles over the 10 min intervals, the mean production rate of CO2 ( MCO2andVCO2) was calculated. All data analysis and statistics were carried out using custom-made peak and valley finding formulas and macros in Excel (Microsoft Corporation), OriginPro 8.5 (OriginLab Corporation) and Stathgraphics Centurion XVI (StatPoint Technology Inc.). In the figures mean values are given with their standard deviations (SD). As the combination of respirometry data and activity detection had shown the most accurate results in previous studies concerning the upper thermal maximum (Klok et al., 2004, Lighton and Turner, 2004 and Stevens et al.